3-12 Customer Programming Software (CPS)
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
CAUTION: Never disconnect the programming cable from the terminal during the programming process, or
power off the PC while the codeplug file is in memory. This will cause codeplug data to be corrupted.
1. Read the master codeplug from the master terminal, or open the master codeplug file from
archive.
2. Select File/Copy Wizard. The first Copy Wizard dialogue box will be displayed.
3. Click the appropriate check box to select the items to be copied, or click Select All option.
4. Select the ‘Power Off’ option, this will automatically reset the terminal after copying.
5. The CPS will automatically search for the connected terminals and will display the connect
operation results. Check the connection results and click Ok to start the cloning. The CPS will
show the progress of this task per connected serial port(s).
Note: If task progress is not shown or an error occurs, go through the checklist in Unable to Copy
Phone.
6. When the process is complete, click Done to exit the Copy Wizard.
To Next Page
Loading...
