3-50 Customer Programming Software (CPS)
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
14.33 Low Voltage Disable Keypad Backlight
Specifies whether the Low Voltage Disable Keypad Backlight feature is supported or not.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.34 DMO Repeater
Indicates whether the terminal supports the repeater feature or not.
The repeater enables to support Direct Mode communications over an enhanced coverage area as
compared to that typically achieved in direct MS-MS operation. Note that an MS will not join a call
initiated via a DMO repeater if it was received directly from the calling Direct Mode MS.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.35 Clear LA Blacklist on Talk Group Change
The Blacklist list stores sites that rejected the Mobile Station (MS) previously. If this feature is
enabled, the list will be cleared each time a new talkgroup is selected.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.36 Remote Programming
If enabled, allows programming a mobile terminal via a wired network without the need of bringing it
manually into programming mode.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.37 Permanent Disable
The feature allows to disable only the MS permanently.
To Next Page
Loading...
