Buttons, Keys and Accessories 3-133
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
28.3.8.3 TXI Mode Started Timer
The entry in this field sets the time that the button must remain pressed before the TXI mode is
started.
The range is from 1 to 5000 msecs and the default is 500 msecs.
28.3.8.4 TXI Mode Cancel Timer
The entry in this field sets the time that the button must remain pressed before the TXI mode is
cancelled and the terminal reverts to normal operation.
The range is from 1000 to 5000 msecs and the default is 2000 msecs.
28.3.8.5 TXI Activation Timer
This is the time delay between TXI being selected and TXI actually starting, it allows time for all on
going procedures to be completed before transmission is actually blocked.
The range is from 1 to 30 seconds and the default is 15 seconds.
28.3.9 Sending Predefined Message
This function sends a predefined message to the address that is already stored in the codeplug.
28.3.9.1 Select Message
Choose a message from a list. The list will include all the predefined messages that appear in the
message list in the CPS.
Related field is:
Paragraph 26.1.2 "Outgoing Mail List"
Note: Sending Predefined Message is only available if the appropriate values are set in the
Outgoing Mail List.
28.3.10 Sending User Defined Message
This function sends a message the user chose from the Templates list in the terminal.
Note: Sending User Defined Message is only available if the appropriate values are set in the
Outgoing Mail List.
28.3.10.1 Select Message
Choose a message from a list. The list will include all the user defined messages that appear in the
message list in the CPS.
Related field is:
Paragraph 26.1.2 "Outgoing Mail List"
28.3.10.2 Send to
Insert the destination ID number (only a valid ISSI will be accepted); or, the user will be able to enter
the address in the terminal while sending the message.
Default value: 0; The user will be asked to insert the address.
To Next Page
Loading...
