Data Services 3-121
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
26.4.17 Store and Forward
This option is enabled/disabled by selecting the check box in this field. This option activates/
deactivates the Message Service Center store & forward feature where the subscriber's outgoing
messages are stored when recipients are not logged onto the system and forwarded when logged
on.
Note: Not all systems support this feature.
26.4.18 Number of Service Centre
The number (address) of the Message Service Centre that is responsible for storing and forwarding
the subscriber's outgoing messages is entered into this field. The address can be up to 25 digits
26.4.19 Default Validity Period
This field defines how long the outgoing message will be held by the message service centre in the
event that the message cannot be delivered to the destination (a destination handset may be
unavailable due to being out of coverage or switched off). To choose the period, place the pointer
into the field value, click on the arrow, and drag the pointer to the desired period. Selecting “No
validity” means that the Message Service Centre will not hold the undelivered message.
26.4.20 Group Call Notification while Composing SDS
Indicates if incoming group call display should be posted to user while composing SDS. If this field is
disabled, the group call will only be heard without display notification.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
26.4.21 Mail out During Group Call
Defines option for sending a text message during active group or broadcast call.
The options are:
• Not Allowed - Not allowed to send text message while there is an active group call.
• Leave Call to send Mail - The call will be disconnected and the text message will be sent.
• Allowed - Text message will be sent without disconnect the call.
The default is set to ’Allowed’.
To select the option, put the pointer into the field value, click on the arrow.
26.4.22 Status During Group Call
Defines option for sending a status during active group or broadcast call.
The options are:
To Next Page
Loading...
