3-80 Customer Programming Software (CPS)
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
To change the setting, select the field value, and select desired setting.
Note: The Default Incoming Minimum Security Class cannot be set higher than the Default
Outgoing Security Class.
19.8.4 Default Outgoing Security Class
This is an additional parameter to DMO talkgroups. It is the default security class for calls and
sending SDS messages initiation. It applies to individually addressed destinations as well as group
addressed destinations that are not covered in Outgoing Security Class.
The security classes are the same as for Default Incoming Minimum Security Class.
To change the setting, select the field value, and select desired setting.
Note: The Default Outgoing Security Class cannot be set lower than the Default Incoming Minimum
Security Class.
19.8.5 Gateway Capabilities Class 2A - 2C
Click to activate/deactivate Boolean flag indicating if the radio shall assume that the relevant
security class is supported by the gateway(s) in operation, or not supported by them.
19.8.6 Repeater Capabilities Class 2A - 2C
Click to activate/deactivate Boolean flag indicating if the radio shall assume that the relevant
security class is supported by the repeater(s) in operation, or not supported by them.
19.8.7 Permit Clear Preemption in 2A / 2B
Click to activate/deactivate Boolean flag indicating if calls in security classes 2A/2B may be
preemted in clear.
19.8.8 Active SCK Subset Number Flag with OTAR
Indicates if the user is allowed to set the active SCK Subset Number while the DM-SCKs are
managed by system via the Over-The-Air-Rekeying (OTAR).
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
19.8.9 Open MNI Security Settings
Click to display a table that provides security settings for open group calls which are identified by the
MNI value.
To Next Page
Loading...
