1-14 Product Overview
6866588D21-D Chapter 1 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
5 Ordering the MTP850 Ex/MTP810 Ex & Accessories
TETRA Subscribers are only available to Accredited Channel Partners who will be advised of the
discount structure that will be applied to these products.
1. Order the main model
2. Order one option from each of the following categories. All 4 categories are mandatory:
l Order either clear or encryption software option (one and only one selection per model) (see notes on
languages below)
l Order antenna option (one and only one selection per model)
l Order battery option (one and only one selection per model)
l Order charger option (one and only one selection per model)
IMPORTANT: Export controls apply when ordering encryption.
3. The following steps are not mandatory.
l Order software features as required. MSPD, GPS and WAP are available as Software Enablement Kits.
l Order Tamper Evident Label if required.
l Add additional hardware accessories as needed.
Note on Software Features GPS, WAP, MSPD and Man Down
• The main model provides a Global Positioning System GPS hardware equipped terminal.
Customers can enable the GPS by ordering the relevant software feature,
see “Ordering the
Software Enablement Kits” on page 1-19.
• The terminal is capable of interfacing with a Wireless Application Protocol WAP server.
Customers can enable the WAP software by ordering the relevant software feature.
• Packet Data (PD) service is a bearer service that allows two parties in a TETRA system to
communicate using the IP protocol. PD is transferred over the air interface using a packet
data channel (PDCH).
Multi Slot Packet Data MSPD allows full usage of a multislot PDCH, which means up to 4
slots can be used for Packet Data transfers depending on available infrastructure resources.
Multislot PD is therefore 2 to 4 times faster than Single Slot PD. The MSPD feature can
operate with Air Interface Encryption.
• The main model provides a Man Down appliance equipped terminal. Customers can enable
the Man Down feature by ordering the relevant software kit,
see “Ordering the Software
Enablement Kits” on page 1-19.
The software features can be ordered independently of ordering a MTP850 Ex/MTP810 Ex terminal,
see “Ordering the Software Enablement Kits” on page 1-19.
For each order a dongle will be provided with the purchased number of enablers.
To Next Page
Loading...
