3-84 Customer Programming Software (CPS)
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
20.2.2 DTMF
If enabled, the keypad will change from an alphanumeric keypad to a DTMF keypad when the
terminal is in either Phone or PABX mode. The user is then able to send DTMF tones, an option
required for over dialing.
This feature is Enabled/Disabled by clicking in the check box.
20.2.3 Group Call Received Tone
If enable the received Group Call Alert will sound.
This feature is Enabled/Disabled by clicking in the check box.
20.2.4 Group Call Audio via MMI
Selecting this option enables the Group Audio sub menu in the terminal’s menu list, if not selected,
the sub menu will not be visible to the user.
20.2.5 Audio Toggle
This field defines whether or not the “Loud/Low” audio soft key is displayed on the terminal screen
during an active group call.
Selecting ‘Always Loud’ will direct the audio to the speaker for the call duration and the soft key will
not be visible.
Selecting ‘Spkr Cntrl’ will display the soft key for user control, allowing the user to direct the audio to
either the earpiece or the main speaker for the duration of call.
20.3 Timers
There are 4 available options in this sub menu. the timers can be set to the factory default by
selecting ‘Reset’ or the user can enter a time in seconds.
20.3.1 Out of Service Timer
This entry defines the period of time in seconds after which the phone will alert the user that it is out
of service. The alert is repeated at this time interval until it regains service.
The range of this time period is 0 - 900 seconds, the default setting is 120 seconds.
To Next Page
Loading...
