Feature Flags 3-49
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
14.25 TNP1 Support
The TNP1 feature will operate only if Packet Data or External Device is enabled in the codeplug (for
example a PPP session with MT2 can be established).
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.26 Selected Network Enabled
If enabled, the Selected Network Enabled option will be displayed on the terminal screen. The
option allows the terminal user to register to a network of choice from an allowed Network List.
Check box to enable this feature.
14.27 Address Book Restriction
When the Address Book Restriction feature is enabled, the user will be allowed to initiate a private/
phone/PABX call if a number stored in the list of received calls exists in the address book.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.28 WAP
If enabled, WAP (Wireless Application Protocol) allows terminal (or device) accessing the internet.
14.29 Mail Out To Group
If enabled, allows the user to send a mail to a group.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.30 Direct Mode (DMO) Semi-Duplex Private Call
Indicates whether the Direct Mode (DMO) Semi-duplex Private Call feature is enabled or disabled in
the phone. Also called DMO Private Call.
In this type of one-way call, the user presses and holds the PTT while talking, and releases the PTT
while listening.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.31 Packet Data Page Enable
Enabling this feature will allow the terminal to display the packet data page.
14.32 Multislot Packet Data
Specifies whether the Multislot Packet Data is supported or not.
When enabled on the terminal and the network, the Multislot Packet Data allows for faster Packet
Data transfer.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
To Next Page
Loading...
