3-146 Customer Programming Software (CPS)
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual March 2009
their own advantages (better position accuracy, less power optimised) and disadvantages (power
optimised but less accuracy).
30.1.12 Accuracy Mode Switching Enabled
If this parameter is enabled, the terminal is able to switch to the High Accuracy mode on emergency
and/or outgoing Status messages.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.1.13 High Accuracy Mode on Emergency
If this parameter is enabled, the terminal automatically switches to the High Accuracy Mode on
emergency. The field "Accuracy Mode Switching Enabled" must also be checked.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.1.14 GPS Location Protocol
In this field you select the over-the air location protocol used for location requests and location
reports.
There are 2 possible choices:
• LIP - Location Information Protocol (ETSI standard)
• LRRP - Location Request Response Protocol (non ETSI standard)
To select the option, put the pointer into the field value, click on the arrow, and drag the pointer to
the desired option.
30.2 LIP Configuration
30.2.1 Send Initialization Request
If enabled, the radio will send an Initialization Request after it is powered up and registered in the
network. After the radio has sent the Initialization Request it expects a LOCATION REPORTING
ENABLE/DISABLE REQUEST from the Location Server to configure its initial LIP settings (for
example whether the radio is globally disabled or enabled for sending location reports). In case it
does not receive an answer from the location server, the radio considers itself disabled for location
reporting.
If this field is disabled the radio will not send an Initialization Request and considers itself enabled
for location reporting.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
To Next Page
Loading...
