Data Services 3-125
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
on the WAP Proxy. Turn the check box on (Enable) or off (Disable) by clicking in the check
box.
Default value: checked.
• SAR Group Size:
Type in the required SAR group size.
Default value: 3.
• Bearer Index:
The bearer interfaces between the terminal and the WAP Proxy. To change the setting, select
the field value, then select desired setting.
Default value: 0. Do NOT change the default value.
26.5.4.1 Bearer Tables
The terminal stores Proxy information. This information includes: the address of each Proxy, the
bearer (or network) each Proxy uses, and the data connection (or Access Point) information for
each bearer. The network uses this information to establish communication with the Proxy.
The terminal also creates a bearer (or network) table that contains information about the bearer for
each Proxy: name, type, and maximum request time. The Client requires this information before
initiating data communication.
Please consult with the Service Provider before filling up these tables.
26.5.4.2 AP (Access Point) Tables
The terminal stores Proxy information. This information includes: the address of each Proxy, the
bearer (or network) each Proxy uses, and the data connection (or Access Point) information for
each bearer. The network uses this information to establish communication with the Proxy.
Please consult with the Service Provider before filling up these tables.
To Next Page
Loading...
