Snohomish County PUD Radio Operations Manual • Rev. 6/03
104
Section VI
Using the Microphone Keypad and Buttons
The microphone has been programmed with some special features. For general
microphone use, see Section V: Idnetifying Controls and Buttons.
In addition to the two user progrmmable buttons “1” and “3” on the keypad,
other features have been pre-programmed. These features are intended to make
the microphone a useful tool in navigating and selecting Zones and Talkgroups.
Using the Microphone Keypad
Yo u D o T h e Mobile Radio Does
1. Press the number “2” on the keypad. This functions the same (“Answer
All”) as the Blue Button on the por-
table radio (see p. 48).
2. Press the number “4” on the keypad. The selected channel number
increases by one. The display now
shows a different Talkgroup.
For example, if the original Talkgroup
display was A1 ECC 1 N, after pressing
the number 4 on the keypad, the new
display would be A2 ECC 2 EV-EA.
3. Press the number “7” on the keypad. The selected channel number
decreases by one. The display now
shows a different Talkgroup.
4. Press the number “6” on the keypad. The Zone letter increases to the next
letter. The display shows the corre-
sponding Talkgroup for the new Zone.
For example, if the original Talkgroup
on display was A1 ECC 1 N, after
pressing “6” on the keypad, the new
display would be B1 ARLINGTON.
5. Press the number “9” on the keypad. The Zone letter decreases by the pre-
ceding letter. The display shows the
corresponding Talkgroup for the new
Zone.
To Next Page
Loading...
