Symbol LS4278 Product Reference GuideA-2
Reconnect Attempt Interval 30 sec 4-15
Modes of Operation
(Point-to-Point/Multipoint-to-Point
Point-to-Point 4-17
Parameter Broadcast (Cradle Host Only) Enable 4-18
Pairing Modes Unlocked 4-19
Pairing on Contacts Disable 4-19
Connection Maintenance Interval 15 min 4-21
Remote Address
(All Bluetooth Host Modes)
No Address 4-23
Authentication Disable 4-23
Encryption Disable 4-24
User Preferences
Beeper Tone Medium 5-6
Beeper Volume High 5-6
Beep on Insertion Enabled 5-7
Power Mode Reduced Power Mode 5-8
Intellistand Idle Timeout 15 min 5-8
Time Delay to Reduced Power Mode 1 sec 5-9
Scan Pattern Multi-line Always Raster 5-10
Scan Line Width Full Width 5-11
Laser On Time 3.0 sec 5-11
Beep After Good Decode Enable 5-12
Transmit Code ID Character None 5-12
Prefix Value 7013 <CR><LF> 5-13
Suffix Value 7013 <CR><LF> 5-13
Scan Data Transmission Format Data As Is 5-14
FN1 Substitution Values Set 5-15
Transmit “No Read” Message Disable 5-15
Table A-1. Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
