Standard Default Parameters A-3
Synapse Interface Standard 5-16
Batch Mode Normal (Do Not Batch Data) 5-18
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC
Compatibles
1
6-6
Country Types (Country Codes) North American 6-7
Ignore Unknown Characters Send 6-8
Keystroke Delay No Delay 6-9
Intra-Keystroke Delay Disable 6-9
Alternate Numeric Keypad Emulation Disable 6-10
Caps Lock On Disable 6-10
Caps Lock Override Disable 6-10
Convert Wedge Data No Convert 6-11
Function Key Mapping Disable 6-11
FN1 Substitution Disable 6-12
Send and Make Break Send 6-12
RS-232 Host Parameters
RS-232 Host Types Standard 7-8
Baud Rate 9600 7-9
Parity Type None 7-10
Stop Bit Select 1 Stop Bit 7-11
Data Bits (ASCII Format) 8-Bit 7-11
Check Receive Errors Enable 7-12
Hardware Handshaking None 7-13
Software Handshaking None 7-14
Host Serial Response Time-out 2 sec 7-16
RTS Line State Low RTS 7-17
Beep on <BEL> Disable 7-17
Table A-1. Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
