Moxa Technologies AWK Series User Manual

AWK Series User Manual
137
Security
Setting
Description
Factory Default
Open
Disable security on the SSID. This is not recommended.
Open
WPA
Use WPA authentication.
WPA2
Use WPA2 authentication. This mode supports IEEE 802.11i
with TKIP/AES + 802.1X encryption.
WPA3
Use WPA3 authentication. This mode supports SAE
(Simultaneous Authentication of Equals) to avoid network
attacks, such as KRACK.
WPA/WPA2 Mixed
Use WPA/WPA2 Mixed authentication. This allows both WPA
and WPA2 clients to connect to the AWK.
WPA2/WPA3 Mixed
Use WPA/WPA3 Mixed authentication. This allows both WPA2
and WPA3 clients to connect to the AWK.
When using any security mode except Open, configure the following settings:
Protected Management Frame
Setting
Description
Factory Default
Disabled
Disable the protected management frame. This option is not
available when using WAP3.
Disabled
802.11w
Use 802.11w protocol as the protected management frame.
WPA type
Setting
Description
Factory Default
Personal
Use WPA, WPA2, and WPA3 with a Pre-shared Key (PSK).
Personal
Enterprise
Use WPA, WPA2, and WPA3 with EAP security.
Primary/Secondary RADIUS Server IP (for Enterprise mode only)
Setting
Description
Factory Default
IP address
Specify the RADIUS authentication server for EAP.
None
Primary/Secondary RADIUS Port (for Enterprise mode only)
Setting
Description
Factory Default
0 to 65535
Specify RADIUS server port number.
1812
Primary/ Secondary RADIUS Shared Key (for Enterprise mode only)
Setting
Description
Factory Default
0 to 128 characters
Enter the secret key shared for communication between AP
and the RADIUS server. The key cannot contain the following
special characters: ` ' " | ; & $
None
Encryption
Setting
Description
Factory Default
AES
Use Advance Encryption System (AES) encryption.
TKIP/AES Mixed
TKIP/AES Mixed*
Use TKIP/AES Mixed encryption. This option provides a TKIP
broadcast key and TKIP+AES unicast key to support legacy AP
clients. This option is rarely used and is not available when
using WAP3.
*This option is available for legacy mode in AP/Master only and does not support AES-enabled clients.
EAPOL Version
Setting
Description
Factory Default
1
Use EAPOL Version 1 as the security authentication method.
1
2
Use EAPOL Version 2 as the security authentication method.
Passphrase (for Personal mode only)
Setting
Description
Factory Default
8 to 63 characters
Enter the passphrase. This is the master key to generate keys
for encryption and decryption. The passphrase cannot contain
the following special characters: ` ' " | ; & $
Check Show Password to display the password in clear text.
None

Moxa Technologies AWK Series Specifications

General

Brand	Moxa Technologies
Model	AWK Series
Category	Network Hardware
Language	English