Moxa Technologies AWK Series User Manual

AWK Series User Manual
153
4. The AWK Series device's CLI interface will be displayed. Refer to the device's CLI User’s Manual for
more information and instructions on how to use the command line interface.
NOTE
To modify the appearance of the PComm Terminal Emulator window, select Edit > Font and then choose
the desired formatting options.
ATTENTION
If you unplug the RS-232 cable or trigger DTR, you will be disconnected and logged out for network
security reasons. You will need to log in again to resume operations.
Configuration by Telnet and SSH Consoles
You can use a Telnet or SSH client to access the AWK Series and manage the console over a network. To
access the AWK Series' functions over the network from a PC host that is connected to the same LAN as the
AWK Series, you need to make sure that the PC host and the AWK Series are on the same logical subnet. To
do this, check your PC host’s IP address and subnet mask.
NOTE
The AWK Series' default IP address is 192.168.127.253 and the default subnet mask is 255.255.255.0
(for a Class C network). To configure the AWK Series remotely over a LAN network, set the PC host’s IP
address to 192.168.127.xxx and subnet mask to 255.255.255.0.

Moxa Technologies AWK Series Specifications

General

Brand	Moxa Technologies
Model	AWK Series
Category	Network Hardware
Language	English