Warning: This is used to notify readers of matters or situations that require extra attention to avoid serious
harm to the user or the device. Here is an example:
WARNING
There is a risk of explosion if the battery is replaced by an incorrect type.
Configuration Reminders
In this section, several examples will be used to remind users when configuring the settings for Moxa’s AWK
Series.
A: About Mandatory Parameters
• The items with asterisks mean they are mandatory parameters that must be provided. In the figure
above, the parameters for Entry Status, Destination, and Interface are required to be able to save or
apply the configuration.
• If an item is marked in red means this item has been skipped. You need to fill in the parameters or you
cannot apply or create the function.
• Some parameter values will be limited to a specific range. If the values exceed the range, it cannot be
applied or created.
• Configuration input fields universally do not allow the following special characters: backslash (\),
apostrophe ('), double quotes ("), backtick (`).
B: Preconfiguring Settings
Some function settings can be configured while the function is disabled. These changes will take effect when
the function is enabled, without having to reconfigure the settings again. For example, on the SNMP
configuration page, users can configure the SNMP Account List settings while SNMP is disabled. When SNMP
is enabled, the previously configured Account List settings will take effect.
To Next Page
Loading...
Need help?
General
