How to Test the AWK Series as a Client
AWK-3252A/AWK-4252A/AWK-1151C
If you are testing the AWK Series as a Client, you will need a second notebook computer (Notebook B)
equipped with an Ethernet port as well as an AP connected to notebook A. Configure the AWK Series
connected to notebook B for Client mode with the correct SSID and credentials matching the target AP.
After setting up the testing environment, open a DOS window on notebook B. At the prompt, type:
ping <IP address of notebook A>
and then press Enter. A “Reply from IP address …” response means the communication was successful. A
“Request timed out” response means the communication failed. In this case, recheck the configuration to
make sure the connections are correct.
To Next Page
Loading...
