Moxa Technologies ioLogik E1212 User Manual

2
2. Initial Setup
This chapter describes how to install the ioLogik E1200.
The following topics are covered in this chapter:

Hardware Installation
 Mounting
 Grounding the Unit
 I/O Channel Jumper Setting
 I/O Wiring
 Communication Port Wiring
 Use the Cable Tie Base to Securely Route a Connected I/O Cable
 Powering Up the Unit

ioSearch™ Installation

Load Factory Default Settings

Moxa Technologies ioLogik E1212 Specifications

General

Cable type	AWG
Module type	Digital
Channel type	-
Signal direction	Input/output
Power consumption	130 mA
Dimensions (WxDxH)	27.8 x 84 x 124 mm
Output current range	0 - 0.2 A
Ethernet LAN (RJ-45) ports	2
Supported network protocols	Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, HTTP
Isolation	3 kV
Channels quantity	16 channels