Moxa Technologies MiiNePort E2-H - Page 102

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-10
Real COM TCP alive check time
Command code: RA
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: MiiNePort’s TCP alive check time.
?GRA1;0
System requests port 1’s TCP alive check time for port 1.
!GRA05
MiiNePort reports TCP alive check time as ‘5’ min.
Real COM max connection
Command code: RM
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: MiiNePort’s TCP maximum connection number.
?GRM1;1
System requests maximum connection number for port 1 and channel 1.
!GRM04
MiiNePort reports maximum connection number as ‘4’.
Real COM Ignores Jammed IP
Command code: RJ
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?GRJ1;2
System requests jammed IP policy for port 1’s channel 2.
!GRJ01
MiiNePort reports ignore jammed IP as ‘Enable’.
Real COM Allows Driver Control
Command code: RD
Command parameters: Two numbers separated by a semicolon (;) denote port index and MCSC channel index.
For an MCSC-disabled port, the channel index is 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?GRD1;0
System requests allow driver control policy for port1.
!GRD01
MiiNePort reports allow driver control as ‘Enable’.
RFC2217 TCP alive check time
Command code: FA
Command parameters: Two numbers separated by a semicolon (;) denotes port index and MCSC channel index.
For MCSC-disabled port, channel index shall be 0.
Reply parameters: 1 (Enable) or 0 (Disable)
?GFA1;0
↲
System requests for alive check time for port1.
!GFA07
↲
MiiNePort reports alive check time is ‘7’.