Moxa Technologies MiiNePort E2-H - Telnet Console; SCM (Serial Command Mode)

MiiNePort E2/E3 Choosing the Configuration Tool
4-3
Telnet Console
Your MiiNePort can be configured over the network with Telnet, which requires that the module has a network
connection and an IP address. We briefly discuss Telnet console configuration in Chapter 5: Initial IP
Address Configuration. All Telnet console commands are introduced in Chapter 7: Web Console
Configuration.
SCM (Serial Command Mode)
The MiiNePort’s SCM (Serial Command Mode) allows the module’s parameters to be retrieved and configured
through the serial port. This is accomplished using specially parsed commands sent to the module through the
serial port.
SCM is often used when your device has already been used in a real application and a configuration change,
such as changing the device’s IP address with the device’s key pad, is required.
Refer to Chapter 7: Web Console Configuration for details on how to access and use the MiiNePort’s SCM.
Refer to Appendix A: Introduction to SCM (Serial Command Mode) for the SCM command set
instructions.