Moxa Technologies MiiNePort E2-H - Command Code for Setting the Configuration

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-16
Command Code for Setting the Configuration
Device Name
Command code: BN
Command parameters: The new device name for the MiiNePort.
Reply parameters: N/A
?SBNMiiNePort@Office
System sets the device name as ‘MiiNePort@Office’.
!SBN0
MiiNePort reports command executed successfully.
Password
Command code: BP
Command parameters: MiiNePort’s console password
Reply parameters: N/A
?SBP1234
System sets console password as ‘1234’ for this MiiNePort.
!SBP0
MiiNePort reports command executed successfully.
Web console
Command code: BH
Command parameters: 1 and web console TCP port to enable web console, or 0 to disable it.
Reply parameters: N/A
?SBH1;80
System sets http console as ‘Enable’ and http port as ‘80’ for this MiiNePort.
!SBH0
MiiNePort reports command executed successfully.
Telnet console
Command code: BT
Command parameters: 1 and telnet console TCP port to enable telnet console, or 0 to disable it.
Reply parameters: N/A
?SBT1;23
System sets telnet console as ‘Enable’ and telnet port as ‘23’ for this
MiiNePort.
!SBT0
MiiNePort reports command executed successfully.
Auto configuration
Command code: BA
Command parameters: 1 if Auto configuration is enabled, 0 otherwise.
Reply parameters: N/A
?SBA1
System sets auto configuration as ‘Enable’ for this MiiNePort.
!SBA0
MiiNePort reports command executed successfully.