Moxa Technologies MiiNePort E2-H - Page 109

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-17
NECI (utility accessibility)
Command code: BU
Command parameters: 1 if NECI is enabled, 0 otherwise.
Reply parameters: N/A
?SBU1
System sets NECI setting as ‘Enable’ for this MiiNePort.
!SBU0
MiiNePort reports command executed successfully.
IP configuration
Command code: NC
Command parameters: MiiNePort’s IP configuration index as shown in the following table
Reply parameters: N/A
0 Static
1 DHCP
2 DHCP/BOOTP
3 BOOTP
4 AutoIP
?SNC0
System sets IP configuration as ‘Static’.
!SNC0
MiiNePort reports command executed successfully.
IP address
Command code: NI
Command parameters: MiiNePort’s IP address.
Reply parameters: N/A
?SNI192.168.1.2
System sets IP address as ‘192.168.1.2’.
!SNI0
MiiNePort reports command executed successfully.
Netmask
Command code: NM
Command parameters: MiiNePort’s Netmask address.
Reply parameters: N/A
?SNM255.255.255.0
System sets Netmask as ‘255.255.255.0’.
!SNM0
MiiNePort reports command executed successfully.
Gateway
Command code: NG
Command parameters: MiiNePort’s Gateway address.
Reply parameters: N/A
?SNG192.168.1.254
System sets Gateway as ‘192.168.1.254’.
!SNG0
MiiNePort reports command executed successfully.