Moxa Technologies MiiNePort E2-H - Page 133

MiiNePort E2/E3 Introduction to SCM (Serial Command Mode) Command Set
A-41
Gratuitous ARP
Command code: VA
Command parameters: N/A.
Reply parameters: 1 and send period if gratuitous ARP is enable; otherwise, reply 0.
?RVA
System requests gratuitous ARP status for alert mail server.
!RVA01;300
MiiNePort reports gratuitous ARP as ‘Enable’ and send period as ‘300’ sec.
Serial Number
Command code: @S
Command parameters: N/A
Reply parameters: MiiNePort’s serial number, in digit notation.
?R@S
System requests MiiNePort’s serial number.
!R@S09527
MiiNePort reports serial number is 9527.
Firmware Version
Command code: @V
Command parameters: N/A
Reply parameters: MiiNePort’s firmware version. Version parts are separated by a single dot, with at least two
parts (major.minor) and at most three parts (major.minor.rev).
?R@V
System requests MiiNePort’s firmware version.
!R@V01.0
MiiNePort’s firmware version is v1.0.
Firmware Build Number
Command code: @B
Command parameters: N/A
Reply parameters: MiiNePort’s firmware build number, eight digits.
?R@B
System requests MiiNePort’s firmware build number.
!R@B009021208
MiiNePort reports build number is 09021208.
MAC address
Command code: @M
Command parameters: N/A
Reply parameters: MiiNePort’s MAC address.
?R@M
System requests MiiNePort’s firmware build number.
!R@M000:90:E8:71:00:10
MiiNePort reports MAC address is 00:90:E8:71:00:10.