HYDROCAL 1001+ Installation and operation manual Page 57/76
4.4. Default Communication Interface Setup
A HYDROCAL 1001+ unit is shipped with the following default setup of the communication interfaces:
RS485
Settings: 19200 Baud, 8 Bit, No Parity, 1 Stop
Answer delay: 0 ms (no delay)
MODBUS: off
Bus Mode: point-to-point
Ethernet
DHCP activated (DHCP Client)
Port: 49152
IP: (192.168.1.32)
Mask: (255.255.255.0)
Gateway: (192.168.1.1)
Note: The TCP/IP settings (in brackets) are not used as the DHCP mode is activated.
To Next Page
Loading...
