59. Press the ▼ key to scroll to the next option,
"Full Wash Delay.”
NOTE: This option allows the Full Automatic
Wash Cycle to be delayed for 45 minutes to
allow adequate recovery time of the water
heating device in specific installations.
60. Press the ✚ key to display the current setting,
no delay or 45 minute delay.
61. Press the ✚ key to select a 45 minute delay
or the key to select no delay.
62. Press the key to enter the selection.
63. Press the ✚ key to return to the main menu.
64. Press the ▼ key to scroll to the next option,
"Service Contact.”
65. Press the ✚ key to select “Paul Mueller
Company.”
66. Consecutively press the ▼ key, scrolling
through the "Service Contact” information
and telephone numbers until “Return to
Menu” is displayed.
67. Press the ✚ key to return to the main menu.
68. Programming is complete, unplug the MTA
from the PLC.
Note: De-energize the power supply to the Sentry II for 5
minutes after making any programming changes.
This will ensure that the changes are stored to the E.Prom of the PLC.
Sentry II with Auto-Dosing Assembly Operating Instructions 50 Effective April 1, 2000
▲
To Next Page
Loading...
