Part Number STH034 3/12 133
Beverage Components
PRESSURE REGULATOR - WATER OR CO
2
Function
Adjusts and maintains pressure.
Specification
WATER
Pressure Setting 30 psig (207 kPa)
CO
2
Pressure Setting 35 psig (241 kPa)
CHECK PROCEDURE
1. Verify incoming supply pressure is within the
minimum and maximum specifications, the
regulator is at setpoint and the supply line is sized
correctly to supply sufficient flow.
2. Energize a valve that uses water or CO
2
and
adjust the regulator to setpoint.
3. Test cycle the valve while observing the pressure
gauge - If regulating valve will not maintain correct
pressure, replace regulator.
To Next Page
Loading...
