Part Number STH034 3/12 41
LOADING BAGS
From the Main Menu select Inventory. One at a time
select the slots with assigned flavors.
1. Position rear groove of the spout on product bag
into slot of the product bin.
2. The spout must snap into slot of product bin.
3. Open the cap on the product bag and tear it off.
4. Return product bin to its position in cabinet.
Select the green check. Select Full Bag. Place cup
under dispenser. Select the pump icon. Dispensing will
display on the screen. If a small amount of product has
been pumped into the cup, select the green check. If
no product was pumped through to the cup, select the
pump icon again, confirm product has been pumped
through and then select the green check. Continue
through all the slots that have been assigned flavors.
Select the return arrow when complete.
Calibration Procedure
• From the main menu select the manager icon.
• Enter the manager’s password.
• Select Configure Slots.
To Next Page
Loading...
