Munters Trio Poultry Controller User Manual

© Munters AB, 2020 199
26.6 Mapping Devices in Expansion
 Install and wire the Expansion unit to the TRIO and to the external devices before
beginning.
 After wiring the Expansion unit to TRIO, go to System > General Settings > Info and
click . Follow the online instructions. TRIO will
not recognize the Expansion until this step is performed.
After wiring devices to the TRIO Expansion Unit, each device must be mapped and then defined.
Mapping and defining devices enables the system software to control each device’s functionality.
CAUTION Mapping MUST match the physical wiring! An error message appears if the physical device
is not wired to the relay or port as defined on the mapping screen..
To map the devices:
1. Go to System > Device and Sensors.
2. Click Expansion.
3. Map the devices as detailed in the TRIO manual. Refer to Mapping Devices, page 50 for more
information.

Munters Trio Poultry Controller Specifications

General

Brand	Munters
Model	Trio Poultry Controller
Category	Controller
Language	English