Munters Trio Poultry Controller - Defining the TRIO RPS; Define the Sensor

© Munters AB, 2020 91
2. Place a known weight on the bird scale and click Done.
The result should be fairly close to the true weight.
7.16 Defining the TRIO RPS
The following section details how to configure the RPS device.
•
Define the Sensor
•
Static Pressure Calibration
7.16.1 D
EFINE THE
S
ENSOR
1. Go to System > Devices & Sensors.
2. Click . The Devices & Sensor screen appears.
3. Click .
4. Click Pressure.
5. Define an analog input port as the pressure sensor. In the following screen, ports 5 is defined as
the pressure sensor.