ValueCut USER MANUAL Automatic Aligning System
63
VC2E-A-00
5.5 Contour Cutting
For accurate contour cutting with AAS function, please proceed the following steps:
Step 1
Using FlexiSTARTER supplied with your ValueCut or a cutting software compatible with ValueCut, create
a contour cutting job file and add registration marks described on 5.2.3.
Note:
To create a contour cutting job file using FlexiSTARTER, see 8. FlexiSTARTER Quick Start
Guide. If you are using other software, please refer to the user guide of the software.
To Next Page
Loading...
