ValueCut USER MANUAL Trouble Shooting
73
VC2E-A-00
7.3 Cutting Plotter/Computer Communication Problems
The messages showed below present problems in relation to cutting plotter / computer communication.
Is the connection cable connected to
the cutting plotter and computer
properly?
Yes No
Has the interface setting been
done correctly?
Refer to Chapter 2 -
Connecting your cutting
plotter.
Yes No
Try the communication between
your cutting plotter and computer.
If it still does not work, have your
cutting plotter serviced.
Refer to the “MISC” key in Chapter
3 - Description of Operation for the
port setup.
If your cutting plotter cannot recognize the
HP-GL/2 or HP-GL commands, please check the
HP-GL/2 or HP-GL commands applied to your
cutting plotter are used properly.
Note:
The computer also needs to set up compatible communication parameters to the cutting plotter set up.
To Next Page
Loading...
