Trouble Shooting ValueCut USER MANUAL
72
VC2E-A-00
2. Media is rolled up during the cutting process
Step 1 Turn off the cutting plotter.
Step 2 Move the pinch rollers to the side.
Step 3 Pull the lever up.
Step 4 Trim off the rolled up part of the media.
Step 5 Reload the material.
3 The media runs diagonally
Step 1 Stop the operation.
Step 2 Move the pinch rollers to the side.
Step 3 Pull the lever up.
Step 4 Reload the media and make sure the media is correctly loaded. (Refer to the alignment ruler)
4. The media lifts
Step 1 Stop the operation.
Step 2 Move the pinch rollers to the side.
Step 3 Pull the lever up.
Step 4 Reload the sheet and ensure there are two pinch rollers on the very two sides of the sheet.
Step 5 Ensure the vacuum is on (check the control panel) and increase the number of pinch rollers.
5. The start and end points of the object are shifted
Step 1 Move the pinch rollers to the side.
Step 2 Pull the lever up.
Step 3 Reload the media and increase the number of pinch rollers.
Step 4 Activate “Over Cut” in “Tool Select” on the control panel if the above does not work.
To Next Page
Loading...
