Myray RX DC - IDENTIFICATION PLATES

EN
OPERATOR'S MANUAL
87
12. IDENTIFICATION PLATES
WARNING:
Never remove the identification nameplates provided on the generator, central control unit and collimator
cone.
Central control unit (NAMEPLATE).
The nameplate is found beside the main switch (WALL-
MOUNTED RX DC Plus and RX DC eXTend versions)
and under the extension arm (RX DC PLUS / I
INCORPORATED versions).
Data given on plate:
- Name of the manufacturer.
- Name of equipment.
- Rated voltage.
- Type of current.
- Rated frequency.
- Maximum power absorbed.
- Serial number.
- Date of manufacture.
X-ray unit head.
The nameplate is found on the lower cover at the back of
the radiogenic unit.
Data given on plate:
- Name of the manufacturer.
- Name of equipment.
- Technical specifications.
- Model and serial number of x-ray tube.
- Device serial number.
- Date of manufacture.
Collimator.
The nameplate for the rectangular collimator is found
outside it.
Details shown on the nameplate:
- Name of the manufacturer.
- Type of cone.
- Serial number.
- Date of manufacture.