NAPCO iSecure User Manual

Napco iSecure Security System All technical manuals are available in PDF format at tech.napcosecurity.com 45
Programming: Motion Sensors
1. Go to www.iSecureByNapco.com and log into your iSe-
cure account.
2. Click Sensor Configuration.
3. In the SENSOR CONFIGURATION screen (shown be-
low), program the installed motion sensors as indicated
(when finished, click Save).
ISEC-MOTION
Wireless Passive Infrared Motion Sensor
SENSOR TYPE
Select "Motion
Sensor".
ENABLE REPORTING
Check to enable central
station reporting
1
2
3
5
6
SENSOR FUNCTION
Select "Instant" or "Interior". When armed "STAY" (usually when sleeping), and
you want the motion to ignore movement within the home, select "Interior". If you
want the sensor to immediately trigger an alarm when motion is detected, select
"Instant".
SENSOR ID
Type in the 7
digit sensor ID
# for the device
4
DESCRIPTION
Type the sensor descrip-
tion you wish to appear
on the keypad display
AREA
Default = 1. See the key-
pad Operating Guide for
the definition of "Area".
CHIME
Check to sound a chime
when motion is detected.
SIGNAL STRENGTH
Relative intensity of the last transmis-
sion, on a scale of 1-10 (10 being the
strongest). Note: A reading of 3 or
less indicates reception may be erratic;
relocate the sensor closer to the Hub.

NAPCO iSecure Specifications

General

Brand	NAPCO
Model	iSecure
Category	Security System
Language	English