NAPCO iSecure User Manual

Napco iSecure Security System All technical manuals are available in PDF format at tech.napcosecurity.com 13
Configure the IBR-TOUCH-WL 7" Touchscreen
1
With power applied to the Go-Anywhere Smart Hub, power the IBR-TOUCH-WL. The unit will start within
about 5 seconds (the unit can be manually powered by pressing and holding the small button on the right side
for 10 seconds). Upon power up, the Setup Wizard will automatically start (follow the sequence of images
starting with step 5). If the Setup Wizard does not automatically start, press and hold the System Settings
("gear") icon, enter your Dealer password, then tap Setup Wizard.
Tap Yes and set the date, time and Time Zone (if neces-
sary). IMPORTANT: Outdated digital certificates will
disallow connection to your security system, as well as
inhibiting necessary automatic firmware downloads.
2
Wait for the system diagnostics process to complete.
Functional components are marked with a check; items
not configured or disabled are marked with an "x". Se-
lections are blank when the Setup Wizard is run for the
first time. Tap Configure to continue.
3
System Settings
button
If you have an ISEE-WAP with existing older iSeeVideo
cameras, tap ISEE Series Cameras; if your system in-
cludes the newer ISV2 models, tap ISV2 Series Camer-
as; for systems without cameras, tap No Cameras
(cameras can always be added later). Note: ISEE and
ISV2 cameras cannot be combined.
Select how the IBR-TOUCH-WL will be used. If it will
only be used as a security system keypad, tap Keypad
Only (jump to step 6). To include video camera and Z-
Wave functions, tap Full Functionality.
4
5
Add the IBR-TOUCH-WL Tablet (Kit 3 Only)
The steps below are the only steps required to add the Kit 3
IBR-TOUCH-WL tablet keypad to the system. DO NOT ena-
ble an additional keypad in iSecure Hub programming.
• First register your Hub and purchase an iSecure Service
Plan at www.NapcoComNet.com,
• Then download the preconfigured devices and central
station information into the Hub at
www.iSecureByNapco.com.
Connect the iSecure Hub to the Customer’s Wi-Fi Network
• From the System Settings "home" screen, click the Cen-
tral Station Reporting button and scroll down. For COM-
MUNICATION TECHNOLOGY, select IP with Cell Radio
Backup.
• Select Wi-Fi is Only IP Path, click Save and the Hub will
reboot.
• After the Hub reboots, click Wi-Fi Networks and select
your Customer’s Wi-Fi network name. If you do not see it
listed, click Search WiFi Networks and check again.
• When the correct network name appears, select it and
then enter the network Password.
• Click Save.
Power Up the IBR-TOUCH-WL
With the Go-Anywhere Hub pow-
ered, power up the IBR-TOUCH-
WL by pressing and holding the
small button on the right side for
10 seconds (the touchscreen will
start within about 5 seconds).
Tablet Setup Wizard
Upon power up, the Setup Wizard
will automatically start. Follow the
sequence of images as shown in
the following steps, as necessary
for the installation type. If the Set-
up Wizard does not automatically
start, press and hold the System Set-
tings ("gear") icon, enter your Dealer
password, then tap Setup Wizard.
System
Settings button
Press and hold to
power the
IBR-TOUCH-WL

NAPCO iSecure Specifications

General

Brand	NAPCO
Model	iSecure
Category	Security System
Language	English