50 All technical manuals are available in PDF format at tech.napcosecurity.com Napco iSecure Security System
Programming: Carbon Monoxide Sensors
1. Go to www.iSecureByNapco.com and log into your iSe-
cure account.
2. Click Sensor Configuration.
3. In the SENSOR CONFIGURATION screen (shown be-
low), program the installed Carbon Monoxide sensors as
indicated (when finished, click Save).
ISEC-CARBON MON
Supervised Wireless Carbon Monoxide Sensor
DESCRIPTION
Type the sensor descrip-
tion you wish to appear
on the keypad display
SENSOR TYPE
Select "Carbon
Monoxide".
SENSOR
FUNCTION
"CO Alarm" is
automatically
selected when
"Carbon Mon-
oxide" is select-
ed as the
"SENSOR
TYPE".
SENSOR ID
Type in the
7 digit sen-
sor ID # for
the device
AREA
Default = 1. See the key-
pad Operating Guide for
the definition of "Area".
ENABLE
REPORTING
Check to enable cen-
tral station reporting
1
2
3
4
5
6
SIGNAL STRENGTH
Relative intensity of the last transmission, on a scale of 1-10 (10
being the strongest). Note: A reading of 3 or less indicates re-
ception may be erratic; relocate the sensor closer to the Hub.
To Next Page
Loading...
