NAPCO iSecure User Manual

48 All technical manuals are available in PDF format at tech.napcosecurity.com Napco iSecure Security System
Programming: Smoke Sensors
1. Go to www.iSecureByNapco.com and log into your iSe-
cure account.
2. Click Sensor Configuration.
3. In the SENSOR CONFIGURATION screen (shown be-
low), program the installed sensors as indicated (when
finished, click Save).
ISEC-SMOKE Supervised Wireless Digital Smoke Sensor
DESCRIPTION
Type the sensor descrip-
tion you wish to appear
on the keypad display
SENSOR TYPE
Select "Smoke
Sensor".
SENSOR
FUNCTION
"Smoke" is au-
tomatically se-
lected when
"Smoke Sen-
sor" is selected
as the
"SENSOR
TYPE".
SENSOR ID
Type in the
7 digit sen-
sor ID # for
the device
AREA
Default = 1. See the key-
pad Operating Guide for
the definition of "Area".
ENABLE
REPORTING
Check to enable cen-
tral station reporting
1
2
3
4
5
6
SIGNAL STRENGTH
Relative intensity of the last transmis-
sion, on a scale of 1-10 (10 being the
strongest). Note: A reading of 3 or
less indicates reception may be erratic;
relocate the sensor closer to the Hub.

NAPCO iSecure Specifications

General

Brand	NAPCO
Model	iSecure
Category	Security System
Language	English