NARDA FieldMan - Page 76

8 Operating modes
76 FieldMan Narda
8.4.4 Bar display
8.4.5 Time curve display in the DATA LOGGER
The bar display graphically shows the progress of the measurement. In addition, the start
time, timer duration and storage interval are specified numerically.
Fig. 9: Progress display via time bar: Activated timer (left), after start (right)
No
.
Activated timer Timer started
1 Animated symbol for activated timer Animated symbol for remaining time
2 Start time of recording Remaining time
3 Time bar of recording duration
4 Recording duration and storage interval
5 Softkey for cancel, stand-by and start Softkey for stop
When viewing saved results via the DATA LOGGER, the results are displayed graphi-
cally as a progression over time. In the process, the up to 32,000 measurement intervals
are condensed to a maximum of 240 measurement intervals to enable display and eval-
uation with the Marker and Peak Marker. In case of later data evaluation on the PC,
detailed evaluation in full time resolution is po
ssible.
The time axis displayed on the device is labeled with the total measurement duration in
the format hh:mm:ss. When the marker is switched on, the maximum value that occurred
in the (condensed) measurement interval is displayed as ACT value together with the
time of the interval end.
1
2
4
3
5