Chapter 12 VirtualBench-Logic Analyzer
© National Instruments Corporation 12-5 Getting Started with VirtualBench
d. Select Edit»Bus settings on the front panel. Refer to the Bus
settings dialog box as shown in Figure 12-3.
Figure 12-3. Bus Settings of VirtualBench-Logic Analyzer.
e. Enter the bus names and bits you want to select for each bus.
f. Click OK to use the settings.
g. On the front panel of the VirtualBench-Logic Analyzer, click Run
to start acquiring data.
Note Refer to the VirtualBench-Logic Analyzer Online Reference for more information
about configuring VirtualBench-Logic Analyzer for your specific application.
To Next Page
Loading...
