4.2 Setting up the Stand-Alone Application
When you launch the KOMPLETE KONTROL software from its installation directory, it starts as
a stand-alone application independently from a host.
By default the application uses the standard audio interface of your computer. In order to use
another audio interface, and receive MIDI notes from the keyboard, you need configure the ap-
plication in its Preferences.
1. In the Main menu click on Edit > Preferences to open the Preferences.
2. Click on Audio to display the Audio page.
3. Select the hardware driver supported by your audio interface from the Driver drop-down
menu.
4. Select the audio interface from the Device drop-down menu.
5. Select the left and right output channels of your audio interface you want to use for KOM-
PLETE KONTROL’s master output in the Komplete Kontrol Out 1 L and Komplete Kon-
trol Out 1 R drop-down menus under Routings.
Setting up KOMPLETE KONTROL
Setting up the Stand-Alone Application
KOMPLETE KONTROL - Manual - 20
To Next Page
Loading...
Need help?
General
