Native Instruments KOMPLETE KONTROL S61 - Host Automation

MIDI output is only supported by the stand-alone application as well as the VST and
AAX versions of the plug-in. The AU (Audio Unit) version of the plug-in does not support
MIDI output.
8.1 Host Automation
When you load KOMPLETE KONTROL as a plug-in in a host, the parameters of the loaded In-
strument, the Scale engine, and the Arpeggiator become available for automation from the
host.
Available Parameters for Host Automation
All parameters available for automation are found in the Perform panel and the Plug-in panel.
Browser controls cannot be automated.
8.1.1 Automation IDs for the Perform Panel
The following automation IDs are reserved for parameters in KOMPLETE KONTROL’s Perform
panel:
Automation ID Parameter
000 Reserved for Instance Recognition
and Automatic Focus Follow
001 Scale On / Off
002 Root Note (Scale)
003 Scale Type (Scale)
004 Key Mode (Scale)
006 Chord Mode (Scale)
007 Chord Type (Scale)
026 Arp On / Off
MIDI Communication
Host Automation
KOMPLETE KONTROL - Manual - 81