The Arpeggiator can still generate pitches above the Max. Key setting.
14.10 Setting the Hold Parameter
The HOLD parameter On / Off.
The HOLD parameter On / Off is available in both Arp and Note Repeat mode. On the key-
board, it is mapped to Button 3 of the Control section when Arpeggiator Edit mode is selected.
The HOLD function allows you to latch the notes played by the Arpeggiator. When set to On,
the Arpeggiator will continuously play a sequence according to the last pressed keys on the
keyboard.
HOLD On / Off is a switch control that lets you select the values On and Off.
►
Pressing any key while HOLD is On will set a new sequence.
►
To stop the Arpeggiator playback, set the HOLD parameter to Off.
Alternatively, you can switch the Arpeggiator completely off to stop playback by pressing
ARP in the keyboard’s PERFORM section. When you switch the Arpeggiator back on,
HOLD will still be active and you can continue to play latched note sequences with the
Arpeggiator.
Playing and Editing the Arpeggiator
Setting the Hold Parameter
KOMPLETE KONTROL - Manual - 205
To Next Page
Loading...
