Using Swing in combination with the Gate parameter adds further variations in note duration.
For example, if Gate is set to 100%, KOMPLETE KONTROL sends a MIDI note-off message
before each note and plays back the sequence legato. If Gate is set to values larger or smaller
than 100%, then notes will be scaled after the value of the Swing parameter has been applied,
leaving the groove intact.
14.7 Setting the Other Parameters
The OTHER parameters Octaves, Dynamic, and Gate allow you to change the range of available
notes for the arpeggiator sequence, as well as their velocity and length.
The OTHER parameters Octaves, Dynamic, and Gate.
14.7.1 Other Octaves
The first OTHER parameter, Octaves, is only available in Arp mode. On the keyboard, it is map-
ped to Knob 6 of the Control section when Arpeggiator Edit mode is selected. It lets you de-
cide the range of the arpeggiator sequence. You can choose to play back your sequence within
the octave of only the keys you pressed on the KOMPLETE KONTROL S-Series keyboard, or
you can select up to eight octaves and let the corresponding notes of your chord or scale be
played back in as many octaves.
Depending on the settings you have made to the Type parameter, the octaves played back can
be above (e.g. Up), below (e.g. Down) or both above and below (Up & Down) the pressed keys.
The Octaves setting includes the following values:
▪ 1
▪ 2
Playing and Editing the Arpeggiator
Setting the Other Parameters
KOMPLETE KONTROL - Manual - 200
To Next Page
Loading...
