8.4.5 Assignments for Knobs
For the Knobs, the Type menu offers the entries Control Change and Program Change. Depend-
ing on the selected entry, the further available options differ subsequently. The following table
details the different combinations of options:
Type Menu Value Mode Menu Range Number Step
Control Change Absolute From 0-126 / To
1-127
Number
(0-127)
Relative Step (-32 to
31)
Relative (Offset) Step (-32 to
31)
Program Change From 0-126 / To
1-127
Mode Menu Values for Knobs
For the type Control Change, a Mode menu allows you to select between three operating
modes:
▪ Absolute: In this mode the control element sends absolute values. The Range From, To, and
Resolution parameters are the same as for the other message types (see above).
▪ Relative: In this mode the sent message is in a +1/-1 fashion — actually 1/127, which is
then understood by the target software as +1/-1 in that case. This allows the control ele-
ment to set the new Control Change value relatively to its current value. Two parameters
are available:
◦ Step: Defines the increment to use. Increase the Step value to trigger greater jumps in
the target parameter value. If you choose a negative value for Step, the control will be
inverted.
MIDI Communication
Using the MIDI Assignment Editor
KOMPLETE KONTROL - Manual - 93
To Next Page
Loading...
