►
When
FINE is selected rotate the LOOP encoder to correct the detected BPM value in fine
steps.
►
When
SCAN is selected rotate the LOOP encoder to scroll through the track. Check if the
Beatgrid stays aligned over the course of the track.
Position-aware Beatgrid Tempo Adjustment
Performance knobs 3 and 4 (
BPM) are scaled based on the viewing position of Beatgrid mode
so that adjustments made far away from the Beatmarker dont result in abrupt changes to the
waveform position. For example, if you are near the Beatmarker at the start of a track and
change the tempo of the Beatgrid, you will see the waveform move under the Beatgrid by a
particular amount. If you then scan later into the track, adjusting the tempo will create a simi-
lar amount of motion on the waveform (rather than a large amount of motion) thus allowing for
precise setting of the Beatgrid tempo over the length of the track.
Beatgrid Zoom Mode
To set the position of the Beatgrid with greater precision you can use the Beatgrid Zoom mode:
Using Your S5—Getting Advanced
Working with Beatgrids
TRAKTOR KONTROL S5 - Manual - 137
To Next Page
Loading...
Need help?
General
Weight and Dimensions
