Native Instruments Traktor Kontrol Z2

6.2.2 Settings on Windows: The Control Panel
On Windows, the settings for the TRAKTOR KONTROL Z2 audio interface are accessed via a
tool called Control Panel. The Control Panel was installed together with the drivers for your Z2
during the TRAKTOR installation procedure. This section describes the Control Panel user in-
terface.
Opening the Control Panel
You can open the Control Panel in various ways:
►
From within TRAKTOR: Go to Preferences > Audio Setup and click the Settings button,
located at the right of the Latency slider and display:
►
From your desktop: Go to Start > Programs > Native Instruments > Traktor Kontrol Z2 >
Traktor Kontrol Z2 Control Panel.
If you cannot find the Control Panel, the driver is most likely not installed at all. In this case,
please re-install the driver as described in the separate Setup Guide. Here is what you get
when opening the Control Panel:
Appendix
The Z2 Audio Interface And Control Panel
TRAKTOR KONTROL Z2 - Manual - 70