Nicolet Systems
1-6 April 27, 2015
Activate the internal batteries
1. The first time the Nicolet EEGwireless32/64 amplifier is used, you must pull the
two plastic strips out from the battery compartment (Figure 1) to activate the
internal batteries for use with the Nicolet EEGwireless32/64 amplifier.
Pull the plastic strip labeled
1 first and then pull the plastic
strip labeled
2 second to guard against damaging the amplifier.
Figure 1
NOTE: The batteries arrive at 40%.
Contact Natus Neurology Incorporated customer service if you
believe your amplifier’s internal batteries need to be replaced.
If the amplifier is going to be stored for extended periods of time (>2
weeks) after pulling the plastic strips, it is recommended to connect the amplifier
to an AC power brick or an external battery pack so that the amplifier can be
used immediately when needed. If the amplifier will be stored on a cart that is
not powered, the amplifier needs to be connected to an external battery pack
during storage.
Do not transfer your amplifier’s internal batteries to another
amplifier.
Nicolet EEGwireless32A
1
1
2
To Next Page
Loading...
Need help?
General
