April 27, 2015 1-11
Introduction
Cleaning the system Turn OFF the system power before cleaning the instrument. Do not permit solutions
or cleaning agents to seep into the electronic portions of the system. Take special care
around controls, connectors and panel edges. Do not use any abrasive cleaners.
Remove any dust from the exterior of the system with a soft brush or clean cloth. Use
a brush to dislodge any dirt on or around the connectors and panel edges. Remove
stubborn dirt with a clean soft cloth slightly dampened with a mild detergent (soap)
or low level disinfectant detergent solution. Allow the items to air dry before next
use.
Use of detergent-disinfectants on skin may cause adverse reactions; therefore, gloves
are recommended when cleaning with these products.
Cleaning the monitor
screen
When the monitor is on, the screen has a slight static charge, which attracts dust. To
remove any dust accumulation, wipe the display screen with a soft brush or lint-free
cloth. You may use an antistatic spray on the screen to reduce static buildup.
To Next Page
Loading...
Need help?
General
