April 27, 2015 5-9
Using the Nicolet system to setup and acquire EEG
Start recording EEG 11. If the Impedance Check panel was enabled to appear automatically when the
Recorder application was started, the system begins recording as soon as you
close the Impedance Check panel.
If the feature was not enabled, select Record start recording.
NOTE: Select Record again to stop recording EEG.
NOTE: If the patient goes out of range while performing an impedance check,
the impedance values will not be recorded.
Disconnecting from
the system
In the event that the amplifier becomes disconnected from the Nicolet acquisition
station or the network, either accidentally or intentionally, the amplifier stores its
neurodiagnostic information onboard. For more information see the Catch-up section
in Chapter 3.
To Next Page
Loading...
Need help?
General
