April 27, 2015 5-11
Using the Nicolet system to setup and acquire EEG
Select the montage
1. From the Control Panel, select the Montage button on the Format palette and
then select the desired montage.
- or -
Select Format > Montage and then select the desired montage.
- or -
Select the desired Montage shortcut button.
- or -
Right-click on the trace labels, select Montage and then select the desired
montage.
NOTE: If the Laplacian button becomes disabled:
1. Open the Calculated Channels editor.
2. Select one (and only one) sensor on the Head view.
3. The Laplacian sensor button will be enabled at this point. Once pressed, you
will be in the Laplacian mode. Subsequent sensor selections will be
weighted appropriately.
To Next Page
Loading...
Need help?
General
